I hope you had used the PS3 controller on your PC successfully. When the LED light is on, unplug the controller to sync via Bluetooth. When it connects, you will get a notification in the system tray.Īllow the ScpToolkit to start with Windows and then simply plug in your PS3 controller again. Your device will always recognize the PS3 controller as an Xbox controller, so adjust the button mapping accordingly.Īfter following everything regarding Bluetooth connection in the above steps, you simply need to unplug the mini-USB cable from the device and wait for a couple of seconds. In the ScpTollkit Settings Manager, you can change some settings like disabling rumble, adjusting analog stick dead zones, etc which you need to leave alone.įor individual games, you have to adjust the control settings. Scroll down and find Dualshock 3 USB Driver installed (and Bluetooth Driver installed if you chose to).
When it detects your hardware, it will show a pop-up on the right side of your screen. Now expand Choose Dualshock 3 controllers to install to see a list of USB devices that are attached to your computer.įrom the list search for the PlayStation 3 controller and check it. Make sure you check the Install Dualshock 3 driver (it should be by default). Youll see a big green button that says Run Driver Installer. SCP toolkit is compatible only with Bluetooth 2.0 or higher dongle that supports Enhanced Data Rate (EDR). If you want to use your PS3 controller wireless, then make sure you have a Bluetooth dongle in. The only way Ive managed to make it work again is install the default bluetooth drivers (From here: then reboot, then replace the driver again with Zadig.exe. Then download the following software requirements on your device.īut it is better to check to avoid any further errors especially when you dont have any knowledge about whether they are available or not. But the next day or the next time I boot the PC, SCP Server/monitor cannot detect the PS3 controller when i press the PS button.
0 kommentar(er)
